Skip to content
  • NSW-first CPD, built by a practising builder
  • Instant PDF certificates
  • Unlimited assessment attempts
  • 12 points a year, sorted
  • 15% off your first order — get your code
  • Content aligned to the NCC 2022
(02) 8006 5827 Log in Get started
NSW · 3 points

How to Interpret and Use the NCC: Structure, Classification and Compliance

'The NCC says' and 'NSW requires' are not always the same question, and confusing them wastes time, fees and credibility. Understand how the Code actually works -- its legal status, its Deemed-to-Satisfy and Performance Solution pathways, and how classification and referenced Standards fit together -- so every compliance question gets answered faster and right.

  • Compliance
  • Phone-friendly, progress saves as you go
  • Assessed — unlimited attempts
  • PDF certificate on completion

Buy this course · $49.00 or save with a points pack

You'll learn: Explain how the NCC gets its legal force in NSW, navigate confidently between Performance Requirements, Deemed-to-Satisfy Provisions and Performance Solutions, correctly identify a building's classification including mixed-use and minor-use situations, and know when a referenced document is a mandatory requirement versus supporting guidance.

  • NSW: 3 points (Compliance)

What’s inside

  1. About this course
  2. reading the code as a system, not a rulebook
  3. Two different questions: what the ABCB does and what your state regulator does
  4. How the NCC gets legal force in NSW
  5. Why the edition matters: amendments and transition periods
  6. The Governing Requirements: how Performance Requirements, DTS and Performance Solutions relate
  7. Reading the document: volumes, defined terms and navigation
  8. Building classifications: what they are and why they exist
  9. Buildings with multiple classifications
  10. Minor use exemptions: when an ancillary use does not force reclassification
  11. Adjoining and attached buildings
  12. Referenced documents: incorporation, not reproduction
  13. Telling mandatory from guidance
  14. Putting it together: a practical workflow for a real compliance question

Plus 4 knowledge checks, 2 site scenarios, 1 drag-and-drop task and an assessment at the end.

Reviewed by a NSW building practitioner.

Buy this course — $49.00

Doing your full renewal?

At this course's rate, 12 points costs about $196.00. The 12 CPD Points pack is $169.00 — save $27.00, and spend the points on any courses you like.

See the point packages →

Already have an account? Log in and your points balance shows here.

Disclaimer

The information provided in this course has been prepared using best endeavours to ensure that it is accurate, current and relevant at the time of publication. However, building legislation, regulations, standards, codes, policies and their interpretation may change over time and, in some circumstances, may be subject to interpretation or vary depending on the specific circumstances of a project.

The information provided is intended as general educational guidance only and should not be relied upon as a substitute for project-specific professional advice or verification.

Builders, contractors and other industry professionals are encouraged to independently verify the applicable requirements for each project, including the relevant legislation, regulations, standards, approvals and authority requirements, having regard to the specific site, building, construction method and circumstances.

PointCPD makes no representation or guarantee that the information provided will be applicable to every project or circumstance and recommends that participants seek appropriate professional or regulatory advice where clarification is required.